Télécharger Imprimer la page

Euromate Nerano Mode D'emploi page 9

Publicité

Safety instructions
• To operate this appliance safely, the user must
have read and understood these instructions for
use before using the appliance for the first time.
• Always keep the operating instructions within
reach.
• If you sell or pass on the device, you must also
pass on these operating instructions.
• Use only rechargeable batteries authorised by the
manufacturer.
• The light source of this luminaire is not replacea-
ble; when the light source reaches its end of life
the whole luminaire shall be replaced.
Only use the item for the purposes of decora-
tion. The item is not suitable for room lighting in
the home.
• If wrongly used, liquid may escape from the bat-
tery. The liquid which escapes can cause skin irri-
tation and burns. Avoid contact under all circum-
stances! If contact occurs, thoroughly rinse with
water. If contact with eyes occurs, seek immedi-
ate medical attention.
Batteries
If batteries are defective, the time that the lights are
on each day decreases greatly.
– Checking the batteries: Cover the photo sensor of
the light. The light switches on.
– Remove defective batteries and dispose of them
in accordance with the regulations.
• If the outside temperature is very low, the voltage
of the batteries drops. This can reduce the output
of the light.
Battery Charging
► P. 2, item 1
Note: Before first use, the lamp should be
charged by Solar Charging for at least 8
hours or USB charging for at least 5 hours.
Solar Charging
– Charge >8 h under the sun
USB Charging
– Pull out the silicone plug
– Turn the silicone plug to the side
– Charge >5 h
• Red light during charging
• Fully charged with green light
Lamp Control
► P. 2, item 2
Fault/malfunction
Short run time.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
On/Off
Solar rechargeab le table lamp
– Press the button one time for switch On/off the
Brightness
– Press and hold button to dim the light
Hue
– Press the button 2 time for switching the CCT
Battery Replacement
► P. 2, item 3
– Turn upside-down
– Unscrew battery cover
Cleaning
– Wipe the lamp regularly with a damp cloth.
Storage and transport
Storing
– Remove batteries.
– Store the device and any accessories in a dry,
– In case of longer periods without operation, pro-
– If the light is not used for an extended period
Transport
– Use the original packaging to ship whenever pos-
Troubleshooting
If something stops working...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
Insufficient battery due to dirty sur-
face?
The lamp is in the shade?
Short daylight hours?
product
Note: Caution: 1 battery is included with the
product. Customer can purchase 2nd bat-
tery if needed.
NOTICE! Risk of damage to the device!
Do not use any sharp or abrasive objects, or
aggressive cleaning agents.
Do not use cleaning solutions.
well-ventilated place.
tect the device and its accessories against soiling
and corrosion.
(overwintering), store it in a dry frost-free location.
sible.
DANGER! Danger to life and limb!
Improper repairs can result in the product
functioning unsafely. This endangers your-
self and your environment.
Remedy
Clean the surface.
Change location.
Charge more than 3–4 days.
GB
9

Publicité

loading

Ce manuel est également adapté pour:

146720146721146722146723