Nominal Voltage:
Working Current:
Ultrasound Frequency:
Radio Waves:
Water Resistance:
Time Modes:
Working Time:
Battery Capacity:
Description of parts [see page 2, f1]
1. Transparent protective cover
2. V-contour roller
3. HD Display
4. Mode switching button
5. Magnetic ring
6. Main head
SONIC Mode
Press and hold the mode switching button for 1 second, an audio signal will be generated
once, the corresponding indicator will light up and automatically turn off after 3 minutes.
RF mode
In SONIC mode, short press the mode switch button to switch, the buzzer will beep once
and the corresponding indicator will be on for a long time
and will turn off automatically after 5 minutes.
EMS mode
In RF mode, short press the mode switch button to switch, the buzzer will beep once and
the corresponding indicator will be on for a long time and turn off automatically after 6
minutes.
Turning off
Manual Power Off: In any mode, press and hold the mode switch button for 1 second to
power off. Automatic shutdown will occur after the device has finished operating in any
mode and will turn off after an acoustic signal.
Not enough power
When the battery level is less than 10%, the white battery indicator will flash slowly once
every 3 seconds and cyclically 3 times. The white slow flash will change to fast flash for the
third time and the buzzer will beep twice until it turns off.
In RF import mode, you can use the device 3 times without charging. The low battery
indication is the same as the previous two modes.
When the battery level is 0%, the buzzer will beep 3 times, the battery will be turned off and
the white indicator will flash for 5 seconds. Then the power will be turned off. The device
cannot start.
Battery charging
The white battery light flashes while charging.
Battery charged
The white battery indicator is on.
Memory function
After a manual or scheduled shutdown, the default is the last step mode on the next startup.
How to use
Below is a demonstration of the process (figure and text below). You can choose any mode
to use it alone or follow all the steps one by one according to the introduction of "Function
Description".
3.7V
SONIC 100-400mA / RF 200-2800mA / EMS 8-30mA
3MHz±10%
1MHz
IPX5
3Min, 5Min, 6Min
<3H
1000 mAH
7. Magnetic base
8. Inductive strip
9. Type C charging port
10. Type C cable
11. Cleaning cloth
EN