Publicité
Troubleshooting
Problem
Cause
1.Installation is not horizontal
Pump runs
all the time
2.There is sludge inside tank
Pump makes
1.The water is siphoning back
loud noise
in the pump
1.Installation is not horizontal
Pump can't
2.The power can't reach pump
start working
3.The voltage isn't correct
Important service guide
Every six months or more often the reservoir should be removed, taking care to clean
he filter, float and reservoir thoroughly prior to reassembly. We recommend this is done
in the Spring and the Autumn, using a chemically compatible anti-bacterial wash.
Take great care to replace the float with the magnet facing upwards.
Warranty
This warranty covers all arts with material or manufacturing faults. The buyer's
only remedy is the replacement or repair of the defective arts. In no case can
labour costs and any on sequential damage be cited as a basis for a complaint.
Any returned units must be complete and must be accompanied by a written list
of the defects certained. We are unable to accept any liability in case of
nonconforming installation or noncompliance with the specifications or maintenance
recommendations.
-23-
Action
Adjust the tank make it level
Clean the inside of tank and float
Check whether the outlet pipe is lower than
pump thus result in siphoning, raise the
condensate pump position
Adjust the tank, check water level
Check power supply
Check the voltage
NOTE:
-24-
Publicité
