DeWalt DW7351 Mode D'emploi

DW7351 Accessory Folding Tables
WARNING: For your own safety, read the tool instruction manual
before attaching the tables. Failure to heed these warnings may result
in personal injury and serious damage to the planer and the acces-
sory. When servicing this tool, use only identical replacement parts.
Have damaged cords replaced by an authorized service center.
Your DW7351 folding table box should include:
2 folding tables
4 springs
4 stepped Allen bolts
SET-UP AND INSTALLATION OF BASE HARDWARE
1. Place planer on a secure table or workbench. Position planer so
the front 3-4" of the base can be accessed from the underside.
2. Secure the rear of the planer to the table/bench with nails or
screws to prevent it from tilting or falling from the table.
Fig. A
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286
E
The following are trademarks for one or more D
the kit box configuration; and the array of lozenge-shaped humps on the surface of the tool.
4 Allen cap screws
4 nuts
Fig. C
WALT power tools: the yellow and black color scheme; the "D" shaped air intake grill; the array of pyramids on the handgrip;
E
WARNING: The planer could tilt or fall from the table if it is not
properly secured opposite the end where the folding table is being
installed. Serious injury may result.
3. Place the spring onto the small end of the stepped Allen bolt.
4. Insert the end of the bolt with the spring around it into the larger
hole on the side of the base.
5. Push the stepped Allen bolt all the way through the hole in the first
rib on the underside of the planer. The spring should engage the
rib slightly and the threads should show on the right side of the
rib.
6. On the underside of the planer, use a wrench to hold the nut in
place while turning the stepped bolt into it. The T-wrench on your
planer can be used to turn the stepped bolt until it is fully secured
(Fig. A).
7. Install the smaller Allen screw into the lower threaded hole
on the side of the base. Use the T-wrench to tighten that fasten-
er securely (Fig. B).
8. Depress the top Allen pin until it is flush with the base and slide
the top hole of the table over the pin and release the pin so they
lock together (Fig. B, C).
9. To attach the table to the rear of the planer, install the bolts and
spring following the above procedure.
Your tables should now fold up and down on the top Allen screw and
rest on the bottom screw while in position for planing.
NOTE: To transport the planer with the tables, fold them up and carry
the unit as recommended by the planer manual.
WARNING: For your own safety, it is recommended that two
people carry this machine or serious injury could result.
TO REMOVE THE TABLES
1. Depress the spring-loaded bolts on the base and slide each end
of the table toward you so they disengage the holes in the tables.
You may want to use the T-wrench from your planer to push the
bolts flush with the base to easily remove the tables.
2. Leave the hardware (stepped bolts and small Allen cap screw) in
the base until you need to re-attach the tables.
Fig. B
(MAY03) Form No. 612069-00 DW7351 Copyright © 2003