Pre-installation
This appliance is intended to be used in household and similar applications such as:
1. Staff kitchen areas in shops, of ces and other working environments;
2. Farm houses and by clients in hotels, motels and other residential type environments;
3. Bed and breakfast type environments;
4. Catering and similar non-retail applications.
PLANNING INSTALLATION
WARNING: Explosion Hazard. Keep ammable materials and vapors, such as gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or re.
□
The refrigerator should be located on a completely at surface.
□
Leave about 2 to 4 inches (5-10 cm) between each side of the appliance and the wall.
□
Leave 12 inches (30 cm) between the top of the appliance and the ceiling.
□
Choose a location which is not exposed to sunlight, high temperature or humid, as humidity may cause stain.
□
The appliance can be adjusted by turning its two legs in the front of the bottom panel when it is unstable.
Turning them in the clockwise direction can raise the refrigerator.
□
The location should be rm and at. An unsecure position may cause noise and vibration. The noise may be
increased if the oor is not rm. Put a sheet under the appliance to solve the heat emission if you need to locate
it onto a carpet.
□
Make sure the adjustable legs are rm on the oor, and set the appliance slope backward slightly to keep the
doors closed tightly.
□
Make note of the position of the contents and retain packaging for future packing and moving.
□
Do not lift by the door handle when moving the appliance.
□
Do not tilt the appliance more than 45 degrees.
□
Avoid strong vibration and collision.
TOOLS REQUIRED
#2 Phillips screwdriver
Flat head screwdriver
5
Please contact 1-855-847-7264 (1-855-VISSANI) for further assistance.
HOMEDEPOT.CA