Publicité
Pairing a device with an app
When you insert batteries into the thermometer, the Wi-Fi icon will start flashing.
If the Wi-Fi icon does not flash, press the pairing button for 5 seconds.
Tap Add Device in the app.
Tap the GoSmart list on the left and then the Thermo-Hygrometer EGS0101 icon.
Follow the instructions in the app and enter the name and password for your 2.4 GHz Wi-Fi network.
The pairing with the app will be completed within 2 minutes; the Wi-Fi icon will be permanently shown on
the thermometer display.
Note: If the device fails to pair, repeat the process. 5 GHz Wi-Fi networks are not supported.
Inserting/Replacing Batteries
1. Open the battery compartment cover on the backside of the thermometer.
2. Remove the depleted batteries.
3. Insert new 3× 1.5V AAA batteries. Make sure you observe the correct polarity.
4. Close the cover.
If batteries are protected by a safety film, remove it first.
Only use alkaline batteries of the same type; do not use old and new batteries at the same time; do not use
1.2V rechargeable batteries.
GB | 8
Publicité
