Publicité
Setting the water volume and desired temperature
A
B
Description of display and touch buttons:
Indicates set temperature
A
Indicates set water volume
B
Lock button
C
Temperature setting button
D
Water volume setting button
E
Confirm button
F
Before first use
• Before first use, the internal tubes need to be rinsed and the thermostat boiling point must be set.
• Set the temperature at 000 (room temperature) and volume at 000 (continuous flow), and allow it to dispense
for ± 10 seconds.
• Then set the temperature at 100 and volume at 000 (continuous flow), and allow it to dispense for ± 1 minute,
so the boiling point detection is finished.
Using the device
• Place your cup on the removable drip tray
• When the device is in standby mode, the lock button and "0" light up on the display.
• Press the lock button
will start flashing on the display.
indicators
B
Note! in case of no action within 10 seconds, the device will automatically switch back to lock mode.
• Press the temperature button
temperature will be shown on the display
Each press will increase the temperature. The preset temperature sequence: 45 °C => 55 °C => 65 °C => 75
°C => 85 °C => 100 °C => 000 (room temperature).
• Press the water volume button
The selected water volume will be shown on the display
Each press will increase the water volume. The preset water volume sequence: 100 ml => 200 ml => 300 ml =>
000 (continuous flow)
• Press the confirm button
device starts to dispense water at the set volume and temperature.
• The device will stop dispensing when the set water volume is reached. The selected temperature & volume
will flash on the display
• When you want to stop dispensing, press the confirm button
above steps.
• When the water level is too low in the water tank
will stop, 5 beeps will sound and a warning symbol "E7" will be shown on the display
Fill the water tank
with cold water up to the "MAX" mark in the tank.
7
• Caution! The water dispensed from the device is hot. Do not touch it to avoid burning yourself.
• Caution! Prevent burns. Do not touch the hot boiling water, the cup or mug are very hot.
• Caution! Prevent burns. When dispensing, keep hands and other body parts away from hot steam.
C
and make sure it aligns with the spout
5
for ± 3 seconds to power ON the device. The temperature
C
to set one of the 7 desired preset temperature levels. The selected
D
at the temperature indicator
2
to set one of the 4 desired preset water levels.
E
to confirm the set temperature and water volume. After ± 5 seconds the
F
, 5 beeps will sound, and the device will automatically switch to lock mode.
2
D
E
F
A
at the water volume indicator
2
once. To dispense again, please repeat the
F
or if the water in the tank runs out during use, the device
7
2
3
and volume setting
A
.
B
.
2
EN 05
Publicité
