Télécharger Imprimer la page

Gumax Glass Line 3,06m Instructions De Montage page 5

Publicité

The support structures of the structure should be vertically levelled.
The wall bracket and gutter should be mounted horizontally level.
The veranda should be mounted at 8 degrees.
The veranda is not intended for walking, standing or sitting on, or otherwise moving about on the roof.
Transport
During transport, secure the Product in such a way that it cannot be damaged.
Transport and store the Product in its original packaging in a safe and dry place at all times.
When moving glass panels, use glass lifters with a minimum carrying capacity of 75 kg per glass lifter to easily handle the
glass.
To prevent damage to the glass panels, it is recommended to store, transport and handle them vertically only and not place
them on a hard or uneven surface.
Means of transport must be suitable for the weight of the transport units and must be approved for transport.
Inspection
Check the contents in advance for quantities and damage and lay out the parts clearly.
Before assembling a part, verify that it is free of defects. If you notice a (possible) defect, take pictures of it and contact your
supplier.
Immediately cease use or installation if a possible defect is detected. If you nevertheless install and/or use the Product,
Gumax
is not liable for any consequences.
®
Installation
Make sure there is a safe environment during installation. Make sure all measures are taken to work safely before starting in-
stallation and make sure no persons not involved in the installation are around. It is advised to remove any obstacles from the
work area before placing the product.
At least 2 adults are required to assemble the product. This way, you can easily screw parts on while someone else holds them
in the correct position. Always use the prescribed bolt and screw connections.
Work safely. Always follow the safety instructions of the tools you use. Always wear safety shoes and safety glasses and use
hearing protection, gloves and a face mask when sawing and drilling.
Do not touch the Product with sharp tools.
Always consult the user instructions of included products and act in accordance with these instructions.
Use only the supplied parts. Use of other items may damage the Product or lead to dangerous situations.
Place glass roof sheets with the Gumax
logo facing downwards.
®
A support structure below a gutter connection point should be sealed at the top when installed and left open at the bottom
to allow water to drain. Even if the support structure is cast in concrete, the water should be allowed to run off. Check regularly
that there is no water in the support structure. This can lead to damage to the support structures if they freeze. Gumax® is not
liable for these damages.
Always transport glass sheets on their side, preferably with suction cups. When glass sheets are picked up horizontally, they
can break due to the tension that is applied to the centre of the sheet.
Place the polycarbonate roof sheets with the UV-resistant side facing up to prevent discoloration.
Condensation can form under the roof sheets of the Gumax
veranda. To prevent moisture damage, it is recommended to only
®
place furniture and terrace decking under your veranda that can withstand condensation water.
2

Publicité

loading

Ce manuel est également adapté pour:

Glass line 4,06mGlass line 5,06mGlass line 6,06mPoly line 3,06mPoly line 4,06mPoly line 5,06m ... Afficher tout