Publicité
English
1. To fix the tool holder on the
machine, introduce the shank and
use the pin for positioning. Tighten
the 3 fixing screws (important, make
sure that the screws have the same
clamping force).
2.
Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
KSE310-K
3. During the mounting or the dismounting
of your cutting tools, block the broach
on flats planned for that purpose, using
the supplied spanner.
4.
The
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
MARK :
empty positions. Use the supplied
protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
RBT
Validation : 14.02.2014
tool shank diameter should never
Never use the tool holder with
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
KSE310-K 1-. Mode
d'emploi
Page : 2 de 4
Publicité
