Publicité
How to Use Adjustable Slicing Disc
Laceration Hazard.
w WARNING
• Handle disc carefully; it is very sharp. Make sure unit is switched to OFF ( ) and is unplugged.
• Always use food pusher to feed food into the chute. Never push food through chute with hands or other objects.
Place Bowl on Base with handle
1.
facing the front. Adjust Disc to
desired thickness by turning the
adjustment post. There are
6 adjustment positions, ranging
from 1 mm to 6 mm (1/32" to 1/4").
Carefully place Adjustable Slicing
2.
Disc straight down onto Motor
Shaft.
Place Lid on Bowl. Raise Locking
3.
Arm up and over Bowl and snap
into place. Plug into outlet.
Place food into Food Chute and use
4.
Food Pusher. Do not fill Bowl above MAX Fill Line.
Select LO speed by turning the Speed Dial to the left.
5.
NOTE: This Food Processor will start in the speed it was
last used.
Press the ON/OFF (I/ ) Switch up to turn ON (I) Food
6.
Processor. Press Switch down to turn OFF ( ).
When finished, switch to OFF ( ). Unplug. Push Locking
7.
Arm back to unlock Lid and lower Arm.
Always remove Lid before removing Bowl to avoid
8.
possible damage to the appliance. Carefully remove Disc
from Motor Shaft using the finger holes. Pour out food.
NOTES:
• Check to make sure no other blades are in the bottom of
the Bowl.
• For smaller, thinner foods, like carrots, cut in half and
load pieces side by side in the Food Chute in an upright
position to prevent the food from falling over. This will
result in more uniform slices.
• LO speed is recommended for slicing and shredding.
7
Publicité
