Options; Opening The Door - Indesit IDCE H G45 B Mode D'emploi

Options

EN
The options allow for customising the selected programme according to one's own needs.
Timed drying
After selecting a programme, press the "Timed drying" button to enter a drying time. Every time this button is pressed, the duration of
the selected drying cycle appears on the display. When pressed the first time, the highest allowed value for the selected cycle appears
on the display. When pressed each of the following times, the set time is reduced until OFF appears.
The buzzer will activate if the timed drying option is not available.
Delay Start
The start of some programmes (see Programmes and options) may be delayed up to 24 hours. Press the button repeatedly to enter
the desired delay time. Before setting a delayed start, make sure that the water container is empty and that the filter is clean.If the
creasecare option is selected, during this phase the clothes will be rotated occasionally to prevent the formation's creases.
High Heat
When a drying time is selected, pressing this button sets a high heat drying and the indicator light above the button lights up. The
timed programmes are pre-set to low heat.
Fast Iron
This option, when selected, delivers for the cycle chosen the best humidity level to help make ironing quicker and easier. In this way
it is possible to achieve a level of additional drying. (see Programmes and options).
Memo
This option allows to store a cycle and the options previously stored with the exception of a delayed start.
• Press and hold the button MEMO for 3 second to store a cycle, it is possible to press this button either during the pause that
during the drying cycle. After selecting the desired cycle and options it is possible to store. When press and hold the button Memo
the LED flashes as well as the time on the display and after 3 second a beep will alert has been memorized.
• To recall the option will simply turn on the dryer, press button Memo and start. It is possible to change the option as for each
cycle, less than incompatibility.
At intervals of 2 minutes will appear on the display the number of the cycle recalled. If it is not stored any cycle, an alarm and an
indicator will signal the absence.
• To record a new program just repeat storage.
Alarm
A buzzer sounds at the end of the drying cycle to signal that the programme has ended and the garments are ready to be removed.
Not all options are available on all programmes (see Programmes and options).

Opening the door

If the door is opened (or the START/PAUSE button is pressed) while a programme is running, the dryer stops and the following may
occur:
• The START/PAUSE button flashes orange.
• When a delayed start is running, the delay countdown continues. It is necessary to press the START/PAUSE button to resume
the "Delay start" programme. The "Delay start" indicator light flashes and the display visualises the time remaining to the start of the
selected programme.
• It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running pha-
se and the START/PAUSE indicator light stops flashing and turns green.
• During the post anti-crease phase, the programme ends. Pressing the START/PAUSE button reactivates a new programme from
the beginning.
• By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green. This
procedure can be used to select the COOL drying programme to cool garments if they are judged to be dry enough.
Press the START/PAUSE button to start the new programme.
Note: If you have a power cut, switch off the power or remove the plug. When power is restored, plug in the machine, press and
hold the ON/OFF button until the dryer reactivates, then press Start/Pause button.
26