Adjusting The Focus - Holex 08 1437 Manuel D'utilisation

8
3. Remove the used batteries.
▶ Always remove and replace all of the batteries.
4. Insert three AAA/LR03 batteries into the battery compartment, paying attention to the polarity
of the batteries.
5. Insert the battery compartment into the torch, paying attention to the direction of the arrows.
6. Replace the battery cover and screw it clockwise to close it.
▶ The torch is now ready to use.
6. OPERATION
en
LED risk group 2 - IEC 62471
WARNING
Risk of blinding and injury to the retina
▶ Never look directly into the light beam.
▶ Do not point the light beam into the eyes or people or animals.
▶ Industrial users must be suitably instructed in accordance with the accident prevention regula-
tions.
6.1. ILLUMINATION LEVELS OF THE TORCH
The torch has two different illumination levels.
 Level 1: illumination up to 250 lm
 Level 2: illumination up to 100 lm
6.2. TURNING THE SPOTLIGHT ON AND OFF
1. Press the on/off button in order to switch on the spotlight.
▶ Level 1 is active.
2. Press the on/off button in order to reduce the light intensity of the spotlight.
▶ Level 2 is active.
3. Press the on/off button in order to switch off the spotlight.

6.3. ADJUSTING THE FOCUS

1. Hold the middle of the torch in one hand.
2. Using the other hand, slide the torch head backwards or forwards.
▶ Adjust the focus continuously.
7. STORAGE
Remove the batteries before storing the torch away.
8. CLEANING
Remove the batteries from the torch before cleaning it. Remove any dirt with a dry cloth.
Do not use any chemical, alcohol or solvent-based cleaning agents.
Instruction manual