ETI Solid State Lighting VAL-QMA Guide D'utilisation Et D'entretien

QUiCk arm moUnt installation instrUCtions
PackagE conTEnTS
Description Quantity
Quick arm mount kit 1 Set
note: Keep your receipt and these instructions for proof of purchase. To avoid possibility of electrical shock or fire, the installation personnel must
have professional electric knowledge. Please wear gloves to avoid injury before installation. If any smoke or spark of the wire happened, please turn off
the power immediately and notify relevant personnel. Please use listed water proof strain relief bushing when connecting the supply cord to the outlet
box.
WarninG: Shut off the power at the circuit breaker or fuse panel before removing the old fixture, ballast, or fluorescent tubes. Do not use any electric
generator to test the LED light. Please abide by related country, regional and local law and regulations when install this fixture. Please turn off the power
before installation or maintenance. Proper grounding is required to ensure safety. Please check if there is any damage during shipping. If so, please contact
manufacturer timely. Please read the installation instruction carefully to check whether all the accessories are available. After confirmation, install the led
light according to installation steps.
If you are unfamiliar with electrical installations, we recommend you contact a qualified electrician to do the installation.
InSTrucTIon
Lock the bracket on the fixture. (M8*25 MM screws. M8
1
washers).
M8 Screws
Bracket
Installation complete.
3
WarninG: Carefully read and understand the information given in this manual before beginning the assembly and installation. Failure to do so could
lead to electric shock, fire, or other injuries which could be hazardous or even fatal. • Ensure the electricity to the wires you are working on is shut off.
Either remove the fuse or turn off the circuit breaker.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
See website for Warranty, Troubleshooting or Care and Cleaning details at www.ETiSSL.com.
Questions, problems, missing parts? Call ETiSSL Customer Service 8 a.m. - 5 p.m., CST, Monday - Friday
Use and Care GUide
bracket
Lamp
Side cover
Square pole
1-855-ETI-SSLI (1-855-384-7754) www.ETiSSL.com
order # 70335101
Quick arm mount kit
Affix the mount to the square pole with bolts, open the bottom cover
2
of the mount bracket, pull the wires into the junction box, and connect
the wires correctly (refer to area light installation instructions for
wiring diagram).
Bolt
Junction box
Square pole
For round pole installation, follow the previous steps. Remember to
4
remove the silicon plate when installing the fixture on round pole.
Round pole
Part # Val-Qma
bracket
Lamp
bottom cover
Lamp
bracket
Silicon Plate