Bora Portamate PM-3900B Manuel De L'utilisateur page 5

Assembly Instructions
9. Carefully lift the saw and place onto the miter saw stand. Be sure the hook
end of the machine mount locks under the top tube as shown in Figure
7. The spring loaded handle should lock under the opposite top tube as
shown in Figure 8.
10. Slide the saw forward or back along the machine mount to best balance
the saw on the stand. Secure the saw by tightening the carriage bolts
installed in Step 8.
Attach the Wheels
1. Attach the axle brackets R to the outside of the leg using (2) 1/4-20 x
1-3/4" Hex Bolts  and (2) 1/4-20 Nylon Lock Nuts  per leg. Align the
axle bracket holes with the holes in the leg so the axle will be parallel with
ground when secured. Figure 9.
2. Slide the 6" Wheel Q onto the axle. The integrated spacer on the wheel
should face the leg. Secure in place with Latch Pin P. Figure 10.
Set-up / Knockdown Procedure
1. Remove the saw from the work stand.
2. Collapse the Extension Supports to minimum size.
3. Depress the snap button on each leg and fold the leg under the Top until
the snap button pops into the closed position. Figure 11.
Figure 6
K
Figure 7
Figure 8
Figure 9
Figure 11
5
K
L
N
M
OPEN
LOCKED

R

P
Q
Figure 10