Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Figure 1
Figure 2:
Legs Represented in Open Position
J
Figure 3
J
Figure 4
Figure 5
Assembly Instructions
Read all assembly instructions completely before attempting assembly.
See parts list on Page 2 for names and pictures of parts. Identify all
components and hardware.
1. Install Leg as shown in Figure 1 to Top Frame and secure with
1/4" - 20 x 1-3/4" Bolt and 1/4" Lock Nut . Insure that Snap Pin is
facing out and securely latches in the open and closed positions.
Do not over tighten. Repeat on remaining three Legs.
Note: The two legs with the additional 4 holes need to be mounted on the
same end of the Top Frame.
O
2. Place top frame upside down on your workbench or work surface. Open
the legs by depressing the snap pins and pivot the legs into the open
position.
3. Install 1-1/4" Tube Plugs O into the bottom of all four legs, as shown in Figure
2. Return unit to upright position.
4. Install the Outrigger Supports into the Top Tube as shown in Figure 3.
5. Install (4) 5/16" - 18 3-Point Knobs J into the threaded holes in the Top
Tubes and Outrigger Supports .
6. Install Support T's into the ends of the Outrigger Supports . Figure 4.
7. Locate the machine mounts (Part# 3042). Carefully review Figure 5. Note
the location of the spring mounted handles; these should be positioned
to the rear of the saw as shown. This allows for easier installation and
removal of the saw.
8. Attach the (2) machine mounts to the saw using 5/16"-18 x 2-1/2" carriage
bolts K at each saw mounting point. See Figure 6. From the bottom,
pass the carriage bolt through the slot in the machine mount, through the
mounting hole and secure with 5/16" flat washer M, lock washer N and nut
L. Hand tighten only.
4
Publicité
Table des Matières
