Typical Wiring Of Actpro 1520E/1500E; Wiring Exit Readers - Vanderbilt ACTpro 1520e Instructions D'installation Et D'utilisation

ACTpro 1520e/1500e Door Controller – Installation and Operating Instructions

2.4 Typical wiring of ACTpro 1520e/1500e

Label Description
A Door contact, normally closed
B Push to exit, normally open
C Door networks
D Controller network
Break glass monitoring, normally
E
closed

2.4.1 Wiring exit readers

For clock and data readers, wire exit readers in parallel but leave the sense line unconnected.
For Wiegand readers, wire the DATA 0 of the exit reader to SENSE on the ACTpro 1520e.
Max length: 100m with 12V DC
Cable: 8 core screened Belden 9504 or equivalent
© Vanderbilt 2018
Label Description
F ACT reader wire colour coding
Ethernet: RJ45
G
Note: All IP device must have a valid IP Address.
Important: Place varistor across all lock terminals.
H
Note: Diagram shows normally energised Magnetic
Lock.
J Break glass unit (double pole)
EN – 9
Installation
A-100440
01.02.2018