Installation - FireAngel P-LINE HT-630 Mode D'emploi Et Guide D'installation

NOTE: HEAT ALARMS SHOULD NOT BE
WALL MOUNTED
Install sufficient alarms to compensate for
closed doors and obstacles, which may
interfere with the path of heat to an alarm
and may prevent occupants from hearing an
alarm
Two storey
dwelling
Bedroom
Living
Room
Dwelling with
one sleeping area
Dining
Kitchen Bedroom Bedroom
Room
Living
Bedroom
Room
Smoke alarms for limited protection
Additional smoke alarms for better coverage
Heat alarms
IMPORTANT: These heat alarms are intended
primarily for use in single occupancy private
dwellings For use in other applications the
manufacturers advice should be sought
4
Loft
Hall Bedroom
Hall Kitchen Garage
Dwelling with more
than one sleeping area
Dining
Kitchen Bedroom
Room
TV
Room
Living
Bedroom
Room
Bedroom

INSTALLATION

IMPORTANT: Please read 'WHERE TO
LOCATE' before installing the alarm
Fit the base plate to the ceiling using the
screws provided (knock-out the tabs as
required)
To fit the alarm to the base plate included in
this pack, position the alarm on the plate,
then turn clockwise until the alarm is locked
into position Make sure that the alarm
is twisted fully The power pack will now
activate The red LED on the front of the
alarm should flash once every 45 seconds to
show that it is active