Publicité
REMOTE CONTROL
1. REC
Press to start/stop recording
2. LED
Press to turn party light on
Press and hold to turn the party light off
3. Sound Effects
Press to emit sound effects
4. Repeat
Press to change repeat mode (one/all) in USB/SD/TF card mode
5. EQ
Press to switch between indoor/outdoor sound modes
6. Mode
Press to switch between the different modes. If without USB/SD/TF inserting [M] button only
stay in BT mode
7. MIC -
Press to decrease volume of the microphone
8. MIC +
Press to increase volume of the microphone
9. Play/pause
Press to start/resume or pause play
10. Volume –/+
Press to decrease/increase volume
11. Previous/next
Press to play previous/next track
12. MIC Priority
Press this button to enable or disable microphone priority; the music is automatically turned
down when you speak through the microphone
13. Karaoke
Press to turn karaoke mode on/off. When on, only instrumental music will be emitted
14. Numpad
Numeric keys
WIRED MICROPHONE OPERATION
Insert the 6.3mm jack of the microphone cable into the microphone input. Switch on the microphone by setting to power switch
to "on".
1. Power
Slide the switch to turn the power of the microphone on/off.
LINK/STEREO (TWS) PAIRING FUNCTION
When having two Fenton Core speaker systems, it's possible to initiate a link (pairing) between the two. Both portable systems
will be emitting the same signal from the streaming audio function. To set up this stereo pairing, please follow the below steps:
1. Turn on the power on both Fenton Core speaker systems.
2. Change the operating mode to BT streaming on both Fenton Core speaker systems.
3. Press [LINK] on any speaker to pair with another speaker to connect. The speaker will give a sound when connection is
completed.
4. Press and hold [LINK] to disconnect.
The optimal connection distance is about 5 meters.
When re-pairing after shutdown or power down of both speaker systems, the pairing will be "remembered". When setting both
speaker systems to BT streaming mode, they will automatically pair after about 5 seconds.
BT CONNECTION
1. Activate the BT on your device (Mobile phone, tablet etc.) from which you want to play the music.
2. See the operating instructions for that device.
3. Press the [M] button and activate the BT-function.
4. Select "Party Speaker Core160" on your BT device and pair.
Attention: BT distance is approx. 10 meter without any barrier.
5
Publicité
