Télécharger Imprimer la page

Hotpoint HCM16 Manuel D'utilisation Et D'installation page 3

Publicité

IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
local inspector's use. Observe all governing codes
and ordinances.
• Note to Installer – Be sure to leave these instructions
with the Consumer.
• Note to Consumer – Keep these instructions with
your Owner's Manual for future reference.
WARNING
EXPLOSION HAZARD
Keep flammable materials and vapors, such as gasoline, away from freezer. Failure to do so can result in fire,
explosion, or death.
WARNING
Plug into a grounded 3-prong outlet.
Do not remove the ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For
personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong (grounding) wall outlet to minimize the
possibility of electric shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly
grounded.
Where a standard 2-prong wall outlet is encountered, it
is your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
The freezer should always be plugged into its own
individual electrical outlet which has a voltage rating
that matches the rating plate.
A 115 Volt AC, 60 Hz, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a
separate circuit serving only your freezer be provided. Use
an outlet that cannot be turned off by a switch. Do not use
an extension cord. This provides the best performance
and also prevents overloading house wiring circuits which
could cause a fire hazard from overheated wires.
READ AND SAVE THESE INSTRUCTIONS
49-1000746 Rev. 0
– Save these instructions for
INSTALLATION
CONNECTING ELECTRICITY
ELECTRICAL SHOCK HAZARD
If you received a damaged freezer, you should
immediately contact your dealer or builder.
Skill Level – Installation of this freezer requires basic
mechanical, carpentry and plumbing skills. Proper
installation is the responsibility of the installer. Product
failure due to improper installation is not covered under
the GE Appliance Warranty. See the Owner's Manual
for warranty information.
Never unplug your freezer by pulling on
the power cord. Always grip plug firmly and
pull straight out from the outlet.
Immediately discontinue use of a
damaged supply cord. If the supply
cord is damaged, it must be replaced
by a qualified service professional with
an authorized service part from the
manufacturer.
When moving the freezer away from
the wall, be careful not to roll over or
damage the power cord.
3

Publicité

loading

Ce manuel est également adapté pour:

Hcm18Hcm22