Publicité
SHOE BOX/WALL PACK SCREW-IN RETROFIT KIT
LED-8091MXXD & LED8091MXXD-HV
INSTALLATION INSTRUCTIONS – LED PANEL
1) Open the fixture and verify that the fan on the driver will point to the fixture lens.
2) Remove the reflector to prevent heat buildup on the LED panel.
3) Clean the lens of the luminaire
4) Remove the protective layer from the double stick foam tape on the panel
5) Place the panel on the flat glass lens (see figure 3)
6) Connect the cable from the base to the panel
7) Close lens to luminaire (see figure 4)
8) Turn on electrical power to the luminaire and verify proper operation.
Figure 1 – Luminaire opened
Figure 3 – LED Panel adhered to
the inside of the glass lens
LIGHT EFFICIENT DESIGN 847-380-3540 www.led-llc.com
INSTALLATION AND USERS GUIDE
Figure 2 – Ballast bypassed and removed,
reflector removed, LED retrofit driver
installed with support legs
Figure 4 – Cable connected
and lens closed
9/19/2024
Publicité
