Publicité
MOUNTING THE POCKET MILL PRO TO THE WORKSTATION
1. Loosen both adjustable handles
(Part # 4) on either side of the
universal plate (Part # 12) that
were just installed and slide the
Pocket Mill Pro onto the universal
plate. See Figure 9. The two
grooves on the universal plate
should slide into the slots of the
PMP.
2. Once the Pocket Mill Pro is on
the Universal Mounting Plate, lock
the adjustable handles. See Figure
10.
SETTING AN ANGLE USING THE MITER ATTACHMENT
1. The Miter Attachment already
comes preset. To adjust and set it to
a desired angle, simply loosen off
the two adjustable handles located
at the back of the miter attachment
and attach to the stainless steel
brackets. (See Figure 11)
2. Using the angular adjustment
knob (Part #14) at the back of the
workstation (see Figure 12 and 13),
rotate the knob away from you to
increase the angle on the miter
attachment. On each side of the
miter attachment it will show you
what angle you are set at (See
Figure 14) or adjust the attachment
until it meets up with your material.
Lock both adjustable handles when
your miter attachment is set.
FIG. 9
FIG. 11
FIG. 13
5
FIG. 10
FIG. 12
FIG. 14
Publicité
