Publicité
4. Operating
4.1 Filling Water
By pulling the back water tank, then use the water container or water pipe to fill up the
water tank until the orange water level indicator reach the top of water level scale
Caution: Do not fill up the water exceed the limit of water level scale to avoid
the water spilling out while moving the air cooler.
4.2 How to use the functions
4.2.1 POWER
Press POWER
button again to turn it off and its Red light is illuminated.
4.2.2 SWAY
@
Press
SWAY©
front grille swing automatically and its light is illuminated. Press this SWAY
again to stop the sway mode, then its light is off.
4.2.3
FAN SPEED
Press SPEED
speeds to low (1), medium (2), high (3), speed lights (1,2,3) indicates selected current
wind speed. The wind speeds change on rotating basis.
4.2.4
NATURAL WIND
Press icon on the control panel or the remote control to turn on NATURAL
mode, press
In this mode, the fan speed operates alternately to imitate natural wind.
4.2.5
COOL@
Enter the COOL mode by pressing COOL
control. To turnoff the COOL mode, press COOL
will automatically exit the COOL mode.
REMARKS: When the COOL mode is activated, the pump inside the water tank will
pump water to saturate the cooling pads. Heat that flows through the cooling pads will
exchange with the water and cool the air flowing through the cooling pads to lower
the temperature. Therefore, a decrease in temperature depends on relative humidity
and air temperature when the unit is in COOL mode. In the case where the fan speed
is high, when the icon is pressed, the fan will drop to the lowest speed for 30 seconds
before resuming the speed previously set.
4.2.6
TIMER
Press
icon on the control panel or the remote control to set the timer.
Each time that the icon is pressed, it will change 1 H, 2H, 4H, 8H (The
unit will be turned off automatically after 1 H, 2H, 4H, 8H)
Instruction
button on the control panel to turn on the air cooler. Press this
button on the control panel or the remote control to let the vertical
@
@
button on the control panel or the remote control to adjust wind
again, the system will stop NATURAL Function.
O
button on the control panel or the remote
O
button again, the system
6
©
button
Publicité
