Publicité
8. MAKING A BEND.
Before starting to bend a rebar make some bends without any accessories on the machine until you
are comfortable with the movement.
1.
Divide the bending plate into 4 imaginary 90º sections.
2.
Select bending direction with the control panel button.
3.
Insert the plate pin to the left of 0º so achieve an angle of 90 º.
4.
Step on the pedal and don´t lift off. The bending plate will move until the pin reaches the inversion
switch.
5.
To make the plate return lift your foot off the pedal and press again and the plate will return.
FINAL BENDING ANGLE ADJUSTMENT.
If you haven´t achieved the bending angle, you require with the pin and you need to make a small
adjustment you can use the black metal handles on the side of the machine to move the support mandrels.
Turn the handle to push the mandrel further away to make a tighter angle and bring it towards to
make a wider angle.
17
ENGLISH
Publicité
