Publicité
GB Assembly
Step 10
1 . Using screws (#5), washers (#6) and nuts (#7), screw the
side leg covers (P14) to their inside.
2 . Screw the front and rear leg covers (P15) using screws
(#4), washers (#6) and nuts (#18).
3 . Attach the levelling feet (P16) to the legs (P13), screwing
them all the way in. Then grab by the top where the
pockets are, turn the table over and set it in the desired
position. By adjusting the feet you can level and adapt
the height of the table.
Step 11
1 . Using nails (#19), fit the pocket casings (#20) in the
designated places. If necessary, trim the ends of the
pocket casings to fit the playing field.
2 . Nail the pins (#3) in the top of the bank at the designated
points (visible from a certain angle and tactile on the
surface of the bank).
The pool table is compatible with Hop-Sport's tops: ping-
pong / dining top and ping-pong / air hockey top.
41
Publicité
