Publicité
Warnings
• The product is a sport accessory, not a toy. It should not be shared for children to play.
• The product should be used for the intended purposes only (i.e. pulse monitoring).
• Before you start to use it, make sure that product is not damaged.
• In case you feel dizziness or any pain, you should stop exercising immediately.
• The product should not be placed next to source of heat such as lamp, radiator, fireplace, because it may cause damage to the product.
• Damaged product does not meet the safety requirements. You should not repair it on your own.
• It is recommended to keep present label.
Information about product
Chest belt detects pulse signal and wirelessly transmits it to the receiving terminal (device
with the same frequency, compatible with belt), on which heart rate reading will display.
Technical data
• Waterproof class: IP67
• Transmission frequency: 5.3 Hz
• Transmission distance: 90 cm
• Power supply: battery CR2032 (battery life - 10 months, when using belt 1h/day)
• Place of use: chest
Assembly
Putting on the belt
1. Put one end of elastic belt (E) to the hole in the connecting part (B).
2. Turn the end of elastic belt (E) to fit it into the hole and press connecting part (B).
3. Put on the belt so that the transmitter (C) firmly touches the chest.
4. Put the other end of elastic belt (E) to the other hole in the connecting part (B).
5. Adjust the elastic belt (E) so that the belt is not loose.
Warning! The belt should be placed on body parallel to the floor and sensors located on right and left side of
the belt should firmly touch the chest.
Using belt
1. Put the belt on your chest. The belt is activated when it is located at a distance of 90 cm from a compatible device.
2. App in the phone: Turn on the Bluetooth in your phone. Start the desired sport app. Start the Bluetooth and connect the belt through it in app settings.
Warning: If the belt doesn't show up as Bluetooth accessory on your mobile, you have to start manual pairing in app.
3. Device compatible with the belt: Fitness device computer connects with the belt automatically when it is within the transmission distance indicated above. Start training
and pulse parameters will be displayed on the screen of training device compatible with the belt.
Warning
1. Belt sensors may not measure pulse accurately if the skin on your chest is too dry. You should moisten the sensors (A), put on the belt and check if it works again.
2. Sensors may not detect the pulse signal if the chest hair is too thick.
Battery replacement
Using coin with proper size, unscrew the battery lid from the transmitter belt and put in the battery with "+" symbol upwards. Close the battery box with lid and tighten.
Environmental protection
This item has been packaged to protect it from potential damage during shipping. The packaging can be recycled. Discard these materials according
to their type.
To protect the environment, take used batteries to the recycling facility. Do not discard used batteries to your household rubbish bins. In this way you
will contribute to environmental protection.
Used electrical devices(including the computer in this item) are recyclable materials-you must not discard them to your household waste as they
may contain dangerous substances for human health and environment! We kindly ask you for your active help in economical management of natural
resources and environmental protection by handing over the used electrical devices to the right recycling facility.
CHEST BELT HS-P095PR
Parts list
A. Sensor
B. Connecting part
C. Transmitter
D. Battery case
E. Elastic belt
Publicité
