Publicité
7
2hrs light ON, then switch to motion
activation
9
Power ON
11
Sensor mode.
Motion detected (ON 30 secs) then
OFF.
13
Battery compartment (at rear). Insert
batteries matching the polarity shown
inside the compartment.
7 Chosing a location
Find a location that exposes the solar module to full sunlight to allow the rechargeable bat-
tery to recharge during the day.
Consider the following:
■
The solar panel should be exposed to maximum sunlight. Do not set up the product in
the shade or under any cover.
■
Avoid the direct proximity of other light sources such as yard or streetlights, otherwise
the product will not switch on automatically at nightfall.
8 Installation
WARNING
Concealed wires. Risk of deadly electric shock when drilling.
Check for concealed wires before drilling.
WARNING
Risk of injury and/or property damage.
Proper installation of concrete wall anchors is crucial to ensure the supported weight is se-
cure. Before installation, verify that the surface is suitable for anchoring. If you are in doubt,
contact a specialist before mounting.
9 Recharge batteries
Important:
To maximize charging efficiency, keep the solar panel(s) clean and free from debris.
■
Solar charge the battery under bright sunlight for at least 8 hours:
– Before first use
– After prolonged periods without exposure to sunlight e.g. rain.
10 Operation
1. Point the remote at the main unit and then press the ON button.
à
The lamp indicator will blink to indicate a signal is received.
à
The indicator will light up to indicate the solar panel is charging the rechargeable bat-
tery.
2. Select a light mode. See section:
Remote control / functions
Note:
Always mode. In this mode the light will switch ON when ambient light falls below a set
level (nighttime). The light will switch OFF when the ambient light rises above a set level
(daytime).
11 Troubleshooting
Problem
Possible causes
The light does not turn on.
The battery power is not suf-
ficient to light the product.
The light does not turn on.
There is a nearby light
source which causes inter-
ference with the product.
The light does not turn on.
The product is switched off.
5
8
3hrs light ON, then switch to motion
activation
10
Increase brightness
12
No function
1. Use the holes on the base as a template
to mark where to drill.
2. Attach the mounting pole to the wall.
3. Insert the mounting pole into the main
unit and then tighten the bolts to secure
it.
[} 4].
Suggestions
Charge the rechargeable
battery.
Place the product in dark-
ness.
Switch the product on.
12 Cleaning and care
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
They damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.
■
Keeping the solar panels clean will maximize charging efficiency.
■
Wipe the product with a fibre-free cloth. Lightly moisten if required.
13 Declaration of Conformity (DOC)
Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau hereby declares that this
product conforms to the 2014/53/EU directive.
■
Click on the following link to read the full text of the EU declaration of conformity:
www.conrad.com/downloads
Enter the product item number in the search box. You can then download the EU declaration
of conformity in the available languages.
14 Disposal
14.1 Product
This symbol must appear on any electrical and electronic equipment placed on
the EU market. This symbol indicates that this device should not be disposed of
as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-
back of waste. Conrad provides the following return options free of charge (more details on
our website):
■
in our Conrad offices
■
at the Conrad collection points
■
at the collection points of public waste management authorities or the collection points
set up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply
in countries outside of Germany.
14.2 (Rechargeable) batteries
Remove batteries/rechargeable batteries, if any, and dispose of them separately from the
product. According to the Battery Directive, end users are legally obliged to return all spent
batteries/rechargeable batteries; they must not be disposed of in the normal household
waste.
Batteries/rechargeable batteries containing hazardous substances are labelled
with this symbol to indicate that disposal in household waste is forbidden. The ab-
breviations for heavy metals in batteries are: Cd = Cadmium, Hg = Mercury,
Pb = Lead (name on (rechargeable) batteries, e.g. below the trash icon on the
left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our
stores or wherever (rechargeable) batteries are sold. You thus fulfil your statutory obligations
and contribute to environmental protection.
Batteries/rechargeable batteries that are disposed of should be protected against short cir-
cuit and their exposed terminals should be covered completely with insulating tape before
disposal. Even empty batteries/rechargeable batteries can contain residual energy that may
cause them to swell, burst, catch fire or explode in the event of a short circuit.
15 Technical data
15.1 Main unit
Rechargeable battery ..................... 3.2 V/DC, 12 Ah, 38.4 Wh LiFePO4
Power ............................................. max. 10 W
Battery recharge time ..................... approx. 6-8 hrs (optimal conditions)
Battery life....................................... approx. 3 days (motion sensor "AUTO" mode)
Ingress protection........................... IP44
Protection class .............................. III
LED................................................. 360 pcs SMD, lifespan: 30,000 hrs
Colour temperature......................... 6000 - 6500 K (cool white)
Brightness....................................... max. 1000 lm
Light sensor thresholds .................. ON: <50 lux / OFF: >1000 lux
Mounting height.............................. 3 - 5 m
Mounting pole (dia.x L)................... 5 x 49
Dimensions (W x H x D) ................. 255 x 58 x 530 mm
approx. 8 hrs (light sensor "Always" mode)
Publicité
