Publicité
UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the equipment is indicated on this type of power supply must be connected. Check that the
mains voltage corresponds to this, all other voltages than specified, the equipment can be irreparably damaged. The equipment
must also be directly connected to the mains and may be used. No dimmer or adjustable power supply.
FRONT PANEL
1. MIC & LINE INPUTS
Combo input jacks for mono signal (for example XLR
microphones or 1/4" line input devices).
2. PHANTOM SWITCH
Use to activate phantom power on the XLR mono microphone
connectors of channel 1 & 2 (+48V phantom power). Turn this
on when using a condenser microphone. The LED will light up
when turned on.
3. STEREO RCA LINE INPUT
Stereo RCA input jacks. Connect with the output of an audio
source with line signal, such as a CD player, tape deck, etc.
4. 2-TK RCA INPUT
Stereo RCA input jacks. Connect with the output of an audio
source with line signal, such as a CD/MP3 player, etc.
5. STEREO RCA OUTPUT (MAIN MIX)
Stereo RCA output jacks. Connect with the input of an
amplifier or a recorder.
6. BT/USB SELECTOR
Change between BT and USB input.
7. 2-TK/AUX SELECTOR
Change between 2-TK and AUX input.
8. CHANNEL 1 & 2 GAIN CONTROL
Turn to determine the gain level of both channel 1 and channel
2.
9. TREBLE & BASS CONTROL
Adjust the high and low tones/frequencies for channel 1 and
channel 2.
10. PAN CONTROL
Pan(orama)/balancing control to determine the position of the channel signal within the stereo image.
You can use the pan controller to assign the signal to just a single output, which provides flexibility in recording situations.
11. CHANNEL 1 VOLUME CONTROL
Turn to adjust the volume for channel 1 (1). The led-indicator lights up when the input signal is too high.
12. CHANNEL 2 VOLUME CONTROL
Turn to adjust the volume for channel 2 (1). The led-indicator lights up when the input signal is too high.
13. INPUT SELECTOR SWITCH
Change the input signal source between LINE-IN and USB/BT.
14. OUTPUT SELECTOR SWITCH
Change the output destination between MAIN MIX and PHONES.
15. LINE/USB/BT CHANNELS VOLUME CONTROL
Turn to adjust the volume for LINE/USB/BT channels.
16. AUX STEREO IN
3.5mm stereo jack AUX input for connecting a variety of external audio devices. Volume can be controlled by the MAIN MIX
controller or the connected audio device.
17. MAIN VOLUME CONTROL
Turn to adjust the volume of the MAIN- (5) and USB channel (23).
18. CLIP LEDS
Will light up when MAIN MIX output signal is too high (left and right channel separately).
19. HEADPHONE JACK
3.5mm output jack, supporting stereo headphone plugs.
20. MIC TO CH2 JACK
3.5mm input microphone jack. Input signal is sent to CH2.
21. HEADPHONES VOLUME CONTROL
Turn to adjust the volume of the headphones channel.
22. ECHO EFFECT
Turn to adjust the echo effect.
4
Publicité
