Publicité
A. Wall mounting
•
Carefully remove the light and accessories from the packaging.
•
Mark position of the mounting brackets on intended surface.
For surfaces made of bricks or similar material, use a masonry bit to drill the marked holes.
•
Insert dowels and attach the mounting brackets included in the suspension kit. For surfaces
made of soft material (wood, drywall, plastic), screws are screwed directly into the surface.
•
Install the light by securing it in the mounting brackets (Fig. 2).
•
Connect the power cord to the light and check for proper operation.
Installation options are shown in Figures 4, 5, 6.
B. Ceiling mounting with suspended (cable) brackets
•
Carefully remove the light and accessories from the packaging.
•
Mark the installation points of the cable brackets on the ceiling.
For surfaces made of bricks or concrete, use a masonry bit to drill holes for
mounting using dowels.
•
Insert the dowels and attach the holders.
For surfaces made of soft material (wood, drywall), screws are
screwed directly into the surface.
•
Attach the cable ends in the holders and in the mounting brackets.
•
Install the light by securing it in the mounting brackets. Adjust the installation height.
•
Connect the power cord to the light and check for proper operation.
5. Safety instructions for safe operation
•
Check the power cord regularly for damage.
•
Do not use the light in excessive humidity.
•
Do not expose the light to direct sunlight for extended periods of time.
•
Wipe off the light with a soft cloth moistened with a mild soap or alcohol solution. If the cover
is damaged, replace it immediately.
•
Light may not be operated without protective cover.
•
Ensure that the power cord is disconnected before performing any technical work.
Fig. 4
Fig. 5
5
Fig. 6
Publicité
