Télécharger Imprimer la page

GASLAND chef BI30SP Instructions D'installation Et D'utilisation page 5

Publicité

Installation & Use
Operation of Controls
The hood is operated by using the push button/touch control on the front panel.
The light switch turns the lamps on and off.
The blower switch turns the blower on to three speed settings:
- Off
- Low Speed
- Medium Speed
- High Speed
- Light
Grease Filters
The grease filters should be cleaned frequently. Use a warm detergent solution. Grease filters are
washable.
Install The Ductwork
Ducting
The hood draws the cooking air saturated with fumes and
odor, through the grease filters and then expels it to the
outside through an outlet pipe.
Caution: To reduce the risk of fire, the use of metal
ductwork is favored. Do not use ductwork made of
flammable material to transport exhaust air.
1. Decide where the ductwork will run between the hood
and the outside.
2. A straight, short duct run will allow the hood to perform
most efficiently.
3. Long duct runs, elbows, and transitions will reduce the
performance of the hood. Use as few of them as possible.
Larger ducting may be required for best performance with
longer duct runs.
4. The air must not be discharged into a flue that is used for
exhausting fume from appliances burning gas or other fuels. Regulations concerning the
discharge of air must be followed. Check with the local authority and building codes for exhaust
ducting requirements.
5. Install a roof/wall cap. Connect round metal ductwork to cap and work back towards hood
location.
8350 Patriot Blvd STE B, N. Charleston, SC 29418
www.gaslandchef.com
Model No. (Item No. )
BI30SP (UT0775E-0108)
Hood
(844) 538-7890
Roof cap
Wall cap
Round elbow
support@gaslandchef.com
4

Publicité

loading

Ce manuel est également adapté pour:

Ut0776e-0108