Publicité
Problem
The appliance is noisy.
The compressor operates continual-
ly.
Water flows inside the refrigerator.
Water flows on the floor.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the desired
result, call the nearest brand-mark
service.
18
Possible cause
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products were put in
at the same time.
The room temperature is too
high.
Food products placed in the ap-
pliance were too warm.
The water drainage plug is not
correctly positioned.
Food products are not wrapped
properly.
Temperature is set incorrectly.
The water outlet is clogged.
Food products prevent that water
flows into the water collector.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often.
Replacing the lamp
1. At the same time, with the fingers expand up and
down the transparent cover and unhook it in the
direction of the arrows.
Solution
Check if the appliance stands stable.
Refer to "Operation" chapter.
Wait some hours and then check the
temperature again.
Refer to climate class chart on the rat-
ing plate.
Allow food products to cool to room
temperature before storing.
Position the water drainage plug in the
correct way.
Wrap the food products better.
Refer to "Operation" chapter.
Clean the water outlet.
Make sure that food products do not
touch the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature de-
crease to room temperature before
storage.
Store less food products at the same
time.
Defrost the appliance.
Open the door only if necessary.
Caution! Disconnect the plug from the
mains socket.
Publicité
