Publicité
Only use the valves with suitable pump adapters,
otherwise there may be damage to the valves.
This product reacts strongly to cold and heat.
Do not use the product if the surrounding tem-
perature drops below 15 °C or rises above
40 °C. Otherwise this may lead to damage.
Make sure the valves are closed tightly after
inflating.
Assembling the
screw-on valves (Fig. B)
Each air bed
is equipped with a threaded
1 2
hole for the valves
.
5
1. Pull the ring of the valve over the threaded hole
so that it fits firmly in the groove.
2. Turn the valve firmly into the threaded hole in a
clockwise direction.
Inflating the product
The product should be inflated by an adult.
CAUTION!
To inflate the product, please use a
commercially available foot pump or
double stroke piston pump with cor-
responding pump adapter.
Do not use compressors or compressed
air bottles to inflate the product. Doing
so may lead to damage.
Stop pumping when resistance increases
and the seams become stretched.
Otherwise the material may rip.
Note: We recommend leaving the inflated
product to air for a few days before using for
the first time. Remove the product from its carry
bag
and unfold.
4
Note: For the valve on the pillow, you will need
a pump with a nozzle adapter (Ø approx.
8.5 mm) (Fig. F).
For the air bed valve
pump with a nozzle adapter, with a diameter
of approx. 17.5 mm (Fig. C).
10 GB/IE
, you will need a
1 2
Inflating the air bed
1. Turn the screw cap of the valve
clockwise direction (Fig. C).
2. Inflate the air bed with the appropriate pump
(Fig. C).
3. Hold the ruler
next to the measuring mark.
6
You will have reached nominal pressure when
the length of the ruler matches the length of the
measuring mark (Fig. D).
4. After reaching the nominal pressure, screw the
valve
in a clockwise direction (Fig. E).
5
Inflating the pillow and
attaching it to the air bed
1. Open the valve
3b
2. Inflate the pillow
3
3. Close the valve (Fig. G) and sink the valve,
applying light pressure (Fig. H).
4. To attach the pillow to the air bed, pull the fas-
tening holes
of the pillow over the fastening
3a
straps
of the air bed (Fig. K).
1b
Note: Only attach the pillow to an inflated air
bed.
Attaching the air beds
The two air beds can be fastened together either
next to one another or on top of one another (Fig.
K) (Fig. L). There are buckles on each side of the
air bed
, which are then attached to the buckles
1a
of the other air bed.
2a
Attaching side by side (Fig. K)
1. Place the air beds next to one another so that
the pillows are placed beside one another and
facing the same direction.
2. Fasten the buckles, as shown in the diagram.
Attaching one on top of the other (Fig. L)
1. Remove the pillow from one of the air beds.
2. Place the air bed with the pillow onto the air
bed without a pillow, and buckle the two air
beds together as shown in the diagram.
in an anti-
5a
(Fig. G).
(Fig. F).
Publicité
