Publicité
3. METHOD OF USE
1. Steps for AC power :
(1) Click power key No.12
(2) Click AC switch No.13
POWER
AC
(3) The AC power supply starts to work
2. Steps for DC power :
(1) Click power key No.12
POWER
(2) Click DC switch No.3
DC
(3) Start DC power supply
3. Steps for LED light :
(1)Click power key No.12
POWER
(2) Long press LED switch No.15 for 3 seconds,Turn on the LED light
LED
(3) Click LED switch No.15 to enter the Lighting Mode
(4) Click LED switch No.15 to enter the SOS mode
(5) Click LED switch No.15 to enter the Strobe Mode
(6) Then, press again to turn off the LED Light
In any of these modes, the light can be turned off by hold down 3 seconds.
Note :
1.When press switch, the light of output port is on, it will be standby state.
2.If the AC port is not used, press the switch button to close it to save power.
5
SAFE POWER STATION PERFECT FOR YOU
Publicité
