Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
22
TRANSPORT AND INTERN AL MOVING
The following specifications are to be considered:
It is recommended the use of qualified and specialized staff to move, transport and install the
equipment. Moving should be executed by lifting
specifications:
by the edge with open lid;
by the base;
For short moving it is possible to use a fork lift and/or manual trolley.
ATTENTION:
carry out all the operations with caution AND RISE THE
EQUIPMENT BY FOLLOWING THE INDICATED ZONE
ATTENTION:
it is necessary to follow the instructions reported in this handbook
to rise and to move the equipment.
23
INSTALLATION
23.1
GENERAL INDICATIONS
23.2
NORMAL WORKING
Connection should be executed by authorized and qualified staff.
Equipment's connection should be linked to the pool system circuit.
Connection should be done by using threaded pipes union which are included in the equipment,
the thread and the diameter are indicated in the components card.
Pipe union exit , included in the equipment, should be connected by a glued smooth pipe (PVC)
During the normal working, the equipment should be placed in a covered and dry area protected
from the direct sunlight irradiation and from heat.
For proper working conditions, the water temperature should range between +5°C and +40°C.
The filter has a flow stream direction – which should be respected – these are indicated by the
arrows situated near the pipe unions.
23.3
STORAGE
During an eventual storage the equipment should be kept in a covered and dry place.
The equipment should be protected from eventual water sprinklings, dust, humidity, collision or
accidental damages.
Advisable room temperature should be included between 0°C and +50°C.
-
'
MANUALE D
USO E MANUTENZIONE
0200200
R
.2.4
25/11/14
EV
DEL
–
INSTRUCTION AND MAINTENANCE MANUAL
the equipment according to the following
L–
'
MANUEL D
UTILISATION ET D
'
28
ENTRETIEN
Publicité
Table des Matières
