Environmental Protection - inventiv 202106 Instructions D'origine

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WORKING HINTS FOR YOUR DETAIL SANDER
If your power tool becomes too hot, especially when used at low speed, set the speed to
maximum and run no load for 2-3 minutes to cool the motor. Avoid prolonged usage at very low
speeds. Always use a
sanding paper suited to the material you wish to sand.
Always ensure the work-piece is firmly held or clamped to prevent movement.
Any movement of the material may affect the quality of the sanding finish.
Start your sander before sanding and turn off only after stopping sanding. For best results sand
wood in the direction of the grain.
Do not allow the sandpaper to wear away, it will damage the baseplate. If the hook and loop
system is damaged your sander will not function correctly. The guarantee does not cover
baseplate wear and tear.
Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces and fine grit for
the final surface. If necessary, first make a test on scrap material.
Use only good quality sandpaper.
The sanding efficiency is controlled by the sandpaper not the amount of force you apply to the
tool. Excessive force will reduce the sanding efficiency and cause motor overload. Replacing
the sanding paper regularly will maintain optimum sanding efficiency.
MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.

ENVIRONMENTAL PROTECTION

Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local authorities or retailer for recycling
advice.
202106 280W DELTA SANDER
22
SAFETY AND OPERATING MANUAL

Publicité

Table des Matières
loading

Table des Matières