Publicité
CHARGING BATTERIES
See Figure 3, page 7.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use.
If the charging docking station does not charge your battery
pack under normal circumstances, return both the battery
pack and charging docking station to your nearest repair
center for electrical check.
Charge time is dependent upon the type of battery pack.
„ Make sure the power supply is normal household voltage,
120 volts, AC only, 60 Hz.
„ Connect the charging docking station to a power supply.
„ With the battery installed, place the tool in the charging
docking station by aligning the raised ribs on the tool
housing with the grooves in the charging docking sta-
tion's cradle.
„ Slide the tool down until it is fully seated in the cradle.
„ Once the tool is seated, the charge time is dependent
upon the type of battery pack.
„ The battery pack may become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 6
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
ILLUSTRATIONS START ON PAGE 7.
5 — English
„ After charging is complete, the charging docking station
will enter into Energy Save mode.
„ Charging docking station will periodically wake from
Energy Save mode to ensure the battery pack remains
in a fully charged state.
„ To remove the tool from the charging docking station, lift
the tool up and away from the charging docking station.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may become
hot. A tool with a hot battery pack may be placed directly
onto the charging docking station but charging will not
begin until the battery temperature cools to within accept-
able temperature range. When the battery pack cools, the
charging docking station will automatically begin charging.
CHARGING A COLD BATTERY PACK
A tool with a cold battery pack may be placed directly onto the
charging docking station but charging will not begin until the
battery temperature warms to within acceptable temperature
range. When the battery pack warms, the charging docking
station will automatically begin charging.
Publicité
