Publicité
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the following purposes:
„ Charging PBLSV719 ONE+ 18V Advanced Stick Vacuum
„ Vacuum storage
„ Onboard accessory storage
NOTICE:
Charge in a well-ventilated area. Do not block charging
docking station vents. Keep them clear to allow proper
ventilation.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
OPERATION
MOUNTING THE CHARGING DOCKING
STATION
See Figures 1- 2, page 7.
WARNING:
Make sure the charging docking station is mounted high
enough to prevent unauthorized activation of the tool
being charged. Unauthorized activation of the tool can
result in serious personal injury.
„ Find desired location indoors, away from any objects that
could block vents on charging docking station. Locate
a wall stud to securely mount charging docking station.
NOTE: Do not place the charging docking station in an
area of extreme heat or cold. It will work best at normal
room temperature.
„ You will need four screws (included).
„ With a pencil, mark four screw holes on the wall using the
holes in the charging docking station as a guide.
„ Using an AC or DC drill, make four pilot holes slightly
smaller than the screws.
„ Using a Phillips screwdriver, install the screws through
each of the charging docking station screw holes and
into the pilot holes.
4 — English
Publicité
