MA grandMA3 onPC command wing Manuel Rapide page 17

Turn on the grandMA3 onPC command wing
1. Unpack the device.
2. Remove the packaging and cushioning material.
3. Place the device indoors on a stable surface.
4. Download the grandMA3 onPC software on www.malighting.com
5. Install the software on your PC or laptop. For minimum requirements see System Requirements grandMA3 in the grandMA3
user manual.
6. Connect the grandMA3 onPC command wing with your PC or laptop using a USB cable.
7. Start the grandMA3 console or grandMA3 onPC software.
8. Insert the power connector into the corresponding jack.
9. Connect the power plug with the mains.
10. Turn on the power switch on the rear panel.
The device starts booting.
To turn off the grandMA3 onPC command wing set the power switch to position O.
Important:
-Show data is only saved in the grandMA3 onPC software.
-For updates use the grandMA3 onPC software.
Important:
You can disconnect the grandMA3 onPC command wing using the grandMA3 onPC software. The DMX output will then
be interrupted immediately.
17
Intended Use
Safety
Support
Transport
Limitations
Quick Start
Maintenance
Disposal
Technical Data
Instances
Declaration of Conformity