Typical Installation; Pre-Installation; Tools Required - Powermate P024-0375SP Mode D'emploi

Key Description
A Air hose
B In-line Filter
C Tee Fitting
Display
Units of Measure
Accuracy
Measuring Range
Max Pressure
Hybrid Hose
NPT inlet
Relief Valve
Batteries
Battery Life
Temperature Range
Use
Nitrogen

TOOLS REQUIRED

Adjustable
Wrench
NOTE: Tools not shown to actual size

TYPICAL INSTALLATION

Key Description
D In-line Oiler
E Air Hose
F Whip Hose

PRE-INSTALLATION

SPECIFICATIONS
LCD (Backlit)
Toggle between PSI, BAR, kPa, kg/cm2
+/- 1.0 PSI to 100 PSI
+/-1.5 PSI from 100 PSI to 130 PSI
+/-2.0 PSI from 130 PSI to 150 PSI
0-150 PSI
150 PSI
15" with 360 degree swivel end
¼"
Built in relief valve to deflate over-inflated tires
(2) 1.5 VDC Triple AAA
Auto shut off after 60 seconds to extend battery life
-20F to 120F*
*Delay may occur in cold temperatures
Use with or without pressure hose to read tire pressures
Compatible with nitrogen
Thread
Seal Tape
Key Description
G Quick Coupler
H Male Connector
I Air Tool
Safety
Goggles
4 - ENG
Figure 1
Key Description
J Female Connector
K Spray Gun
#0 Phillips
Head
Screwdriver