Publicité
The lights and the fan motor should be switched ' FF' to set the timer.
Push the LE button '-' until the LE lights will ash :
O
LE
T
LE
hile the 5 minutes timer is running, It is available to stop immediately the boost speed by pressing the
led button 5.
hile the 5 minutes timer is running, the indication of saturation of the lters is switched ' FF'.
If a pre-set stop for the hood is switched ' N' and the 5 minutes timer is still running, the boost speed will
be switched ' FF' together with the pre-set stop for the hood after the count down of 5, 10 or 15 minutes.
It is available to stop the boost speed before the count down of the preset stop of the hood by pressing
the led button 5.
This function allows you to program the cooker hood to automatically stop cooking after a pre-set period.
The lights and the fan motor should be switched ' FF' to set the timer.
Proceed by repeatedly pressing the LE button 5 (Boost speed):
Two ashes of the LE button 1
Three ashes of the LE button 1
Four ashes of the LE button 1
ne ash of the LE button indicates the function is switched ' FF'.
ou can switch the cooker hood ' N' and ad ust the speed. The LE buttons 2, 3 and 4 will ash to
indicate the fan motor is switched ' N' and which speed has been selected.
ne ash
stop after 15 minutes.
Two ashes
stop after 10 minutes.
Three ashes
stop after 15 minutes.
I
After 200 hours use,
lters. (See chapter on ' aintenance').
To reset the 200 hours timer back to zero requires the motor and lights must be switched ' FF' then and
proceed as follows:
Press the LE button '+' for 3 to 4 seconds and the LE lights 1,2,3, 4 and 5 will ash to con rm the
programme has been reset to zero.
8GB
I
After 400 hours use,
lter and clean the metal grease lters. (See chapter on ' aintenance').
To reset the 400-hour timer the motor and lights must be switched ' FF'.
Push the LE button '+' for 10 seconds.
ne ash of the LE lights 1,2,3,4 and 5
Two ashes of the LE lights 1,2,3,4 and 5
Instructions for replacing the active charcoal lter are given in the chapter on 'Recycling'.
our cooker hood is supplied with a deactivated remote control receiver. To use the cooker hood with a
remote control re-programme the hood as follows:
Press the LE button (Lighting) '1' while the motor and lights are switched ' FF', until the LE lights 1 will
ash to con rm the programme has been activated :
O
LE
T
LE
Caution, the remote control handset must be tted with standard LR03-AAA size 1.5V zinc-carbon alkaline
batteries as illustrated Fig. . These batteries should give a long life and constant discharge throughout their
life. These batteries must be disposed of properly and could explode if damaged or exposed to heat.
5
5 minutes delay.
5
10 minutes delay.
5
15 minutes delay.
LE
will indicate that you must clean the metal grease
LE
will indicate that you must replace the active charcoal
function is switched ' FF'.
function is switched ' N'.
O
O
ON
ON
GB
11
Publicité
