Publicité
down until they snap into position, and then connect the ducting 150mm (6 INS) and secure the connec-
tions with appropriate clamping rings or adhesive tape (Fig. 8).
b. Before tting the chimney to the canopy make the electrical connection as described in the section
titled ELECTRICAL.
c. Each chimney stack consists of two sections. Fit the upper sections (Fig. 2a - item 7) rst by expand-
ing the chimneys slightly around the bracket and secure the chimney stacks to the brackets using the
screws provided.
d. Check the vertical of the chimney.
e. Pull on the lower chimney item 5 and secure it temporarily unscrewing a little bit the lower self tapping
screws as illustrated in Fig 9.
IN THE RECIRCULATION MO E
a. Fit the recirculation spigot R onto the chimney bracket using the same xing screws.
b. Connect the ducting 150mm (6 INS) not provided between motors item 6 and the recirculation spigot
and secure the connections with appropriate clamping rings or adhesive tape (Fig. 6).
c. Before tting the chimney to the canopy make the electrical connection as described in the section
titled ELECTRICAL.
d. Each chimney stack consists of two sections. Fit the upper sections (Fig. 2a - item 7) rst by expand-
ing the chimneys slightly around the bracket and secure the chimney stacks to the brackets using the
screws provided.
e. Check the vertical of the chimney.
f. Pull on the lower chimney item 5 and secure it temporarily unscrewing a little bit the lower self tapping
screws as illustrated in Fig 9.
ITTIN
THE CANO
10) Place the canopy under the chimney and x it with the 6 TH 5 16 screws provided as illustrated in
Fig. 10. A
11) Screw the lower self tapping screws of the upper chimney and t the lower chimney section item 5 by
expending slightly it onto the canopy .
12) Connect the connector, check the connectors of the motor and place the cover as illustrated in Fig.
11.
13) Test the lights and the fan motor.
14) Remove the metal grease lters. Insert the charcoal lter into the base of the motor housing and
secure the lter with two securing straps A as illustrated Fig. 6.
15) Fit the metal grease lters.
ONTO THE CHIMNE
GB
4
4
9
Publicité
