Publicité
Before Use:
1.
Carefully remove your heater from its shipping container.
2.
Ensure that your heater's Power Control Switch is in the 'O' position.
3.
Place your heater on a firm, level surface. Completely uncoil the power cord, and connect
your heater directly into a120 Volt, grounded AC electrical outlet.
CAUTION: Ensure that the plug fits tightly into the electrical outlet. A loose fit can cause
overheating and damage the plug.
NOTE: The power cord and the plug may feel warm during normal operation.
NOTE: The power cord has a polarized plug (with one blade wider than the other) that
will only fit in a polarized outlet one way. If it does not insert easily try reversing the plug.
If it still does not fit contact your electrician to replace your outlet.
DO NOT defeat the safety purpose of the polarized plug.
CAUTION: TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT
OPERATING INSTRUCTIONS
Choose Your Power Setting:
•
II HIGH: 1500 watts, I LOW: 750 watts, FAN ONLY (no heat), 0 OFF
NOTE: The HIGH setting can be used to warm the room quickly; when a comfort level
has been reached, the LOW setting can then be used to conserve electricity.
•
Setting the Thermostat:
1. Turn the Temperature Control Switch clockwise, to the highest setting.
2. When the desired room temperature is reached, slowly rotate the temperature Control
Switch counter-clockwise until the heater turns off automatically.
NOTE: Your heater will now turn on and off automatically to maintain the desired room
temperature.
•
Fan:
1. Turn the Power Control Switch to the FAN ONLY setting.
2. Turn the Temperature Control Switch clockwise, to the highest setting, or to the point at
which the fan turns on to maintain the current temperature.
NOTE: Although the Fan operates off of the thermostat, no heat will be generated when
the Power Control Switch is in the FAN ONLY position.
Cleaning Instructions:
1. Turn the Power Control Switch to the '0' position. Disconnect the power cord from the
electrical outlet.
WARNING: Do not expose the heating elements or switches to water, cleaning liquids or
other chemicals, as fire, electrical shock, personal injury and properly damage can occur.
CAUTION: Do not use gasoline, benzene or thinner to clean your heater, as these chemicals
can cause surface damage.
2. Use a vacuum cleaner with a crevice tool to remove dust from the interior or your heater.
4
Publicité
