Publicité
WARRANTY AND AFTER-SALE SERVICES
Warranty
Warranty service as stated on the warranty card
The manufacturer shall not be held liable for any damage caused by improper use of the product.
CHANGING THE DIRECTION OF THE DOOR OPENING
Disassemble the refrigerator/freezer door
1. Use a tool to remove the screw off the hinge cover, and then remove the latter. Insert the communi-
cation line to the hole on the cabinet top (20.1)
2. Use a tool to remove the 4 screws off the upper hinge cover and then remove the latter. Pry up the
door bush and small end cap cover on the door (20.2)
3. Insert the door bush and door communication line into the hole on the door and then put on the
small end cap cover (20.3)
4. Use a tool to remove the 2 screws as shows in the below figure to remove the hole cover on the
cabinet top and get the cabinet communication line out of the hole.Pry up the small end cap cover
on the door and get out the door bush and door communication line (20.4)
5. Insert the door bush into the round hole on the door and then put on the small end cap cover (20.5)
6. Move the refrigerator door upward over 500mm to remove the door (20.6)
7. Use a tool to remove the 3 screws off the middle hinge cover and then remove the middle hinge
(20.7)
8. Move the freezer door upward over 500mm to remove the door (20.8)
9. Remove the adjustable front feet under the lower hinge; use a tool to remove the 4 screws from the
lower hinge and then disassemble the lower hinge (20.9)
10. Door disassembly is finished (20.10)
Assemble the door, lower hinge accessories to the corresponding positions of the other side.
11. Use a tool to get the door bush out as shown in the below figure and assemble it to the correspond-
ing position of the other side (20.11)
12. Use a tool to remove the screws off the stopper ass as shown in the below figure and then assem-
ble them to the other side of the door (20.12)
13. Use a tool to remove the axle and two stoppers on the lower hinge and then assemble them to the
position as shown in the below figure (20.13)
Assemble the refrigerator door and freezer door to the opposite side.
14. Remove the adjustable front foot as shown below by hand and then assemble the lower hinge to the
other side of the cabinet and fix the screws by using a tool (20.14)
15. Assemble the shorter adjustable front foot to the lower hinge side and adjust the height of the foot to
make the refrigerator stay in level (20.15)
16. Put on the freezer door and turn the middle hinge by 180
the cabinet; use a tool to screw up the 3 screws to fix the middle hinge (20.16)
17. Put on the refrigerator door and assemble the upper hinge to the other side of the cabinet; use a
tool to screw up the 4 screws to fix the upper hinge. After that, connect the door communication line
and the cabinet communication line and then put on the upper hinge cover and fix it using a screw.
18. Assemble the hole cover to the other side of the cabinet and use a tool to screw up the hole cover
(20.17)
19. Door disassembly is finished here. Figure of door opening from the right (20.18)
20. Figure of door opening from the left (20.19)
and then assemble it to the other side of
O
45
Publicité
