Publicité
FCC RF Interference Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment causes harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the following
measures.
Reorient or relocate the receiving antenna.
Increase the space between the equipment and receiver.
Connect the equipment into an outlet on a circuit di erent from that to
which the receiver is connected.
Only a shielded interface cable should be used.
Finally, any changes or modifications to the equipment by the user not expressly
approved by the grantee or manufacturer could void the user's authority to
operate such equipment.
DOC Compliance Notice
This digital apparatus does not exceed the Class A limit for radio noise emissions
from digital apparatus set out in the radio interference regulation of Canadian
Department of Communications.
CE Compliance
This monitor complies with the basic protection requirements
of the Electromagnetic Compatibility (EMC) Directive
2004/108/EC for electrical and electronic equipment imported
into the European Union (EU):
The electromagnetic disturbance generated by the apparatus does not exceed
the level specified in the harmonized EMC Standards for this type of apparatus.
It has a level of immunity to the electromagnetic disturbance to be expected in
its intended use, and should operate without unacceptable degradation of its
specified performance.
4
Publicité
