Publicité
12
English
'Unplug for use' symbol
How do I use my appliance and the attachments?
Shaving
4 Insert the USB supply unit into the wall socket.
5 Place the appliance in the charging stand.
Specific models only: The light ring on the bottom of
the charging stand lights up and rotates quickly.
-
After approximately 5 minutes, the light ring
rotates slower. The battery now contains enough
energy for one full shave.
-
As the appliance continues to charge, the light
ring becomes brighter and rotates slower.
-
When the appliance is fully charged, the light ring
lights up fully and stops rotating.
6 After charging, remove the USB supply unit from the
wall socket and pull the small plug out of the
charging stand.
The 'unplug for use' symbol flashes to remind you to
disconnect the appliance from the wall socket and
remove the small plug from the appliance before you
switch it on.
Warning: Always check the appliance and all
accessories before use. Do not use the appliance
or any accessory if it is damaged, as this may cause
injury. Always replace a damaged part with one of
the original type.
Note: This appliance is waterproof. It is suitable for use in
the bath or shower and for cleaning under the tap. For
safety reasons, the appliance can therefore only be used
without cord.
You can use this appliance either wet or dry, or even
under the shower. For a wet shave, apply some water and
shaving foam or gel to your skin and rinse the shaving
Publicité
