Publicité
EN
• Only use Ingersoll Rand charger with Ingersoll Rand IQV12, IQV20, and IQV40 Series Li-ion batteries. Use of other batteries or chargers
may create a risk of fire or may cause battery to burst when charging. Personal injury or property damage may result.
• Charger is not user serviceable. Repair should only be carried out by an Ingersoll Rand Authorized Service Center. User service may result
in electric shock, fire and/or serious personal injury.
• The BC1110/BC1120 is a Class A product. In a residential, commercial or light industrial environment it may cause radio interference.
This product is not intended to be installed in a residential environment; in a commercial and light industrial environment with connection to the
public mains supply, the user may be required to take measures to reduce interference.
• This product is not intended to be used by travelers.
Product Parts Information
• The use of other than genuine Ingersoll Rand replacement parts may result in safety hazards, decreased tool performance and increased
maintenance, and may invalidate all warranties.
• Repairs should be made only by Authorized trained personnel. Consult your nearest Ingersoll Rand Authorized Service Center.
Product Specifications: Battery Charger
Models
BC1110
100-240V AC ~ 50-60 Hz,
Charger Input
30W, 50-70VA
Charger Output
12.6V DC, 2.0A
Battery Models
BL1203 (2.0Ah)
USB Output
Instructions for Charging Battery
The charger shall be installed near a socket-outlet that is easily accessible.
Do not charge battery pack when temperature is below 0°C (32°F) or above 45°C (113°F).
Completely charge new battery packs before using. Charging time is approximately 60-90 minutes. Unplug charger and remove battery pack
when not in use.
The dual bay charger is capable of independent and simultaneous charging of 12V and 20V batteries.
Action
Condition
Plug charger into AC
Power On (Stand-By)
power outlet.
Charging
Insert battery pack
into charger.
Fuel gauge will indicate state of charge.
Communications Failure
Battery Identification/Read Fault
Reinsert battery. Battery may be defective.
Initial Temperature
Charging paused until battery has returned to
safe temperature.
Time Out
Charge time exceeded. Battery may be defective.
In Cycle Temperature
Charging paused until battery has returned to
safe temperature.
Over Voltage
High voltage detected. Battery may be defective.
Over Current
High current detected. Battery may be defective.
Charge Completed
Remove battery pack. Battery Pack Removed.
Legend:
ä Flash
l On
EN-4
BC1121
100-240V AC ~ 50-60 Hz,
100W, 160-215VA
12.6V DC 2.0A/
21V DC 4.0A
BL1203 (2.0Ah), BL2005 (1.5Ah), BL2010 (3.0Ah),
USB Type A, 5V DC, 500mA, D+/D- Connected, 200Ω
m Off
WARNING
CAUTION
BC1221
100-240V AC ~ 50-60 Hz,
220-240V AC ~ 50-60 Hz,
200W, 320-395VA
12.6V DC, 2.0A (x2)
21V DC, 4.0A (x2)
BL2012 (2.5Ah) and BL2022 (5.0Ah)
BC1110
Charger Display
Green
Red
1 x ä
1 x ä
m
ä
m
l
m
2 x ä
3 x ä
m
4 x ä
m
5 x ä
m
m
6 x ä
l
m
1 x ä
1 x ä
BC1221-EU
BC1161
100-240V AC ~ 50-60 Hz,
200W, 340VA
100W, 160-215VA
42V DC, 2.0A
BL4011 (2.5Ah)
BC1121, BC1161, BC1221, and BC1221-EU
Charger Display
Alarm
(Sound)
Green
Red
l
m
---
---
l
m
Low ♪
m
l
Low ♪
m
2 x ä
Low ♪
3 x ä
m
Low ♪
4 x ä
m
Low ♪
5 x ä
m
Low ♪
m
6 x ä
High ♪
l
m
High ♪
l
m
TL-IQV-UIM-BL-BC_ed1
Fuel
Gauge
mmmm
ämmm
Ê
mmmm
mmmm
mmmm
mmmm
mmmm
mmmm
llll
---
Publicité
