Preparation Of The Weather Station - RADEMACHER ReWiSo Notice De Montage Et D'utilisation

i
Installation of the Weather Station and Connection of the Drive

Preparation of the Weather Station

1 = Cover with
rain sensor
2 = Cover latch
3 = Printed circuit
board
4 = Housing lower
section
Unlock the cover and lift
off from above.
The cover of the weather station with the rain sensor is latched at the lower edge on
the left and right (see Fig.). Remove the cover from the weather station. Proceed
carefully to avoid tearing off the cable between the printed circuit board in the lower
section and the rain sensor in the cover.
GB
169