Publicité
Perform Initial Configuration (For model with console port)
1. Connect a PC to the switch console port using the included console cable.
2. Configure the PC's serial port: 115200 bps, 8 characters, no parity, one stop bit, 8 data bits, and no flow control.
3. Log in to the CLI using default settings: Username "admin" and password "admin."
Note:
For further information on switch configuration, refer to the Web
Management Guide and CLI Reference Guide.
Logging on to the equipment
1. Connect the RJ-45 interface cable of a switch with a computer using a network cable.
2. Set the TCP/IP properties of the computer, see the Appendix: Setting up your computer.
3. Logging on to the equipment: Open a browser and type 192.168.1.1 in the address bar, and then
press Enter; in the pop-up login interface, enter the factory logon username "admin", password
"admin" and click OK.
- 4 -
Publicité
