Publicité
HOW TO SHAVE (FIG.1)
Do not press too hard against the skin.
1. Press the ON button (5) to turn on the shaver.
2. Move the shaving heads over the skin using gentle circular movements to capture all the
mustache.
3. Go against the direction of the facial hair growing, or shave in the same direction if your
skin is sensitive.
4. For trimming the sideburns and moustache, push down the pop-up trimmer switch (8)
and move it downwards applying gentle pressure. Post shaving, it is suggested to press
ON/OFF button (5) again to switch off the shaver. You may put the protective cap (1) to
avoid any kind of damage.
5. The battery indication led (6) is green when the shave is running normally.
6. The battery indication led (6) turns to red when the battery voltage is low, then the
battery needs to be charged.
MAINTENANCE AND CLEANING (FIG. 2)
For convenience and better shaving results, it is recommended to clean the product
regularly after use. Cleaning the product regularly will keep it in good condition, avoiding
bad odors or bacteria, and maintaining good shaving results.
1. Make sure the product is completely switched off before cleaning.
2. Press the release button (4) to open the shaving head (3).
3. Rinse the shaving head (3) and hair chamber directly with water. For a deep cleaning,
remove the shaving unit pulling it outwards.
4. Then turn the lock counterclockwise: ① pulling it up ② to unlock and remove the
retaining frame.
5. Then remove and clean one set of blade assembly at a time.
6. Separate the blade and ring blade, and clean both parts under water or by brush (10).
7. After cleaning the blade assembly set, it is recommended to lubricate them with some
lubricating oil. Then install them on the shaving unit and switch it on and off a few times.
Regular oiling enhances the run time of the product.
Attention: Do not clean more than one blade assembly at a time, since they are all
matching sets. If you accidentally interchange them, it could influence the shaving results.
16
Publicité
