Publicité
•
Check the tightness of the attachment system before each use by pulling the bedside sleeper
in a direction away from adult bed.
•
If there is any gap between the bedside sleeper and adult bed DO NOT use the product.
•
The maximum distance between the crib and the parent's bed should be 2 cm.
•
Assemble, unfold and fold the product ONLY by an adult.
•
Do not allow children under 3 years of age till fully assemble the product to avoid access to
small and disassembled parts.
•
Any plastic cover should be removed, destroyed or kept away from children to avoid
suffocation.
IMPORTANT! The diagrams and figures in this instruction are illustrative and indicative only.
Follow exactly the instructions and sequence for assembling and operating with the product.
Check the securing of the fixation after each operation.
THE BABY COT SET INCLUDES: Folding cot; Second layer; Toy bar with 4 toys; Nursery purse;
Carrying bag.
ASSEMBLY AND OPERATION: ATTENTION! Follow exactly the instructions and sequence for
assembling the product as described in the text and illustrations. Never put fingers inside the
corners or any other moving parts of the cot while folding and unfolding the cot.
1. UNFOLDING THE COT - Remove the cot from the bag. Loosen the self-adhesive tapes that
hold the mattress. Remove the cot and set the mattress aside. Place the cot upright and separate
the legs by pulling both sides of the cot in opposite directions. Unfold all four corners of the crib
so that you can catch the locking mechanisms in the middle of each side. Lift the sides of the
crib until they lock. Push the centre of the crib down until it is fully unfolded and locked (you will
hear a clicking sound). Place the mattress in the cot with the soft side up. Attach the mattress
to the base.
2. FOLDING THE COT - Remove the mattress. Pull the strap of the locking mechanism on the
bottom of the cot as MAXIMUM as possible to release the lock. ATTENTION! Failure to pull the
mechanism to its highest position may damage the locking of the sides. Warranty conditions do
not include damage caused by improper use of the product. Find the buttons in the middle of
each side. Press them and fold all sides of the crib. Take the mattress and wrap it around it. Close
the package by wrapping the velcro straps around the mattress. Put the cot in the carrying case
and fasten the zipper.
3. INSTALLING THE SECOND FLOOR LEVEL - Install the second level with its zipper and the one
on the sides of the cot. Place the tops of the 4 metal tubes in the pockets at the top of the second
level and connect the tubes. Place the mattress on the second level and secure it with the straps
under it.
4. ATTACHING THE COT TO THE ADULT'S BED - Тakedown the sideway panel of the bed and lock
it in the crib's basis, using the locking button. Use the two seat belts provided in the kit to secure
the baby cot to the parent's bed. Lock the buckles under the cot on both sides, then secure the
belts around the structure of the parent's bed, starting at the bottom and going up, and finally
tightening the buckles under the bed. To secure the baby cot when it is next to the parent's bed,
pull the straps once more to make sure the crib is securely attached to the parent's bed.
ASSEMBLY AND OPERATING INSTRUCTIONS
20
Publicité
