Publicité
1
1
E
Package Contents
N
φ294*H125.8mm
CS10
Dust Cover
Bracing Bridge*2（Optional）
2
Hardware Introduction
RJ-45 Port
3
Installation Method 1：Use the assembly fixing bracket
has a load-bearing capacity greater than 4.7KG, you may choose not to use the bracket
for additional support, but the
assembly fixing bracket
1. Place the
assembly fixing bracket
T-bar drop ceiling grid and triangular drop ceiling grid).
2. Connect the ethernet cable and cover it with the dust cover.
3. Install CS10 along the opening circular of the drop ceiling grid, pushing it towards
the ceiling.
4. Hold the device by hand and securely tighten the four screws on its surface in
a clockwise direction. Adjust the lower surface of the CS10 to align it flush with the
ceiling tiles.
1
2
φ294*H3.4
D=268mm
White Mesh Cover
Assembly Fixing
(Black Optional)
Bracket
× 6
M3*4CMHOZN3
Deployment Instruction
Templete
Quick Start Guide
Safety rope passes through here
Mic(Do not poke it )
is still necessary.)
onto the drop ceiling grid support (compatible with
Power supply: PoE+Switch
2
The need for an auxiliary bracing bridge during the installation of the CS10 depends
mainly on the frame and the load-bearing capacity of the suspended ceiling tiles.
• Common suspended ceiling tiles materials include gypsum, metal, and PVC.
• If your suspended ceiling tiles has a load-bearing capacity lower than 4.7KG, it is
recommended to use a bracing bridge.
• The suspension bracket requires the load-bearing capacity of your ceiling frame to
be no less than 6.3KG.
• The adjustable range of the bracing bridge is 400-438mm/600-638mm/2'.
• The slot width compatibility of the ceiling grid (T-bar) includes: 22mm, 24mm, 32mm,
and 38mm.
• The slot width compatibility of the ceiling grid (triangle) includes: 25mm, 30mm,
35mm.
1. The installation of CS10 requires a certain level of professional expertise.
We strongly recommend entrusting this task to professional construction
workers whenever possible.
2. If you choose to install it yourself, please make sure to have someone assist you
for safety reasons.
3
Installation
• Remove the ceiling and draw auxiliary lines at the midpoint of the length
and width on the back of the ceiling.
• Align the auxiliary lines with the deployment instruction templete's
guidelines and cut openings in the ceiling.
Opening diameter: 265-270mm; Opening depth: 120mm.
•
Reset (Long poke
for 5 seconds to
reset.)
4
• Installation completed (main body).
(If your ceiling
• Attach the mesh cover magnetically to the CS10.
The following installation steps will demonstrate using the bracing bridge to secure
the CS10. If your ceiling has a load-bearing capacity greater than 4.7KG, you may
choose not to use the bracing bridge for additional support, but the
bracket
is still necessary.
assembly fixing
Publicité
